9/25/2023 0 Comments Audio converter pro input level![]() Using a CM-LUR1 or CM-LUX1 galvanically isolates the audio, allowing you to connect via phono cables to an unbalanced input without compromising the distributed feed. It is particularly useful where a shared balanced audio feed needs interfacing to an unbalanced input on one or more pieces of equipment. This unit is a passive version of the RB-LU4 (though only 1 x stereo channel), and provides you with an alternative to having to interface a balanced output to an unbalanced input via specialist cables (either by shorting the non-phase to ground or disconnecting it). It is transformer balanced, with a 2:1 ratio, so 6dB of attenuation is added to the input to help interface with the lower signal levels associated with consumer outputs. This product allows the connection of a stereo balanced line input via 2 x female XLRs to a stereo unbalanced output on phono connectors. Selecting a region changes the language and/or content on -LUX1 Balanced to Unbalanced Audio Converter The meter LED turns on when the signal is limited. Limiter: Attenuate audio that exceeds a specified threshold.The gain reduction meter shows the level of reduction in audio level. The ratio parameter can be used to control the change in dynamic range. This lets you make use of both consumer and professional-level audio equipment. Expander: Increases the dynamic range of the audio signal by attenuating audio below the specified threshold. If you’re working solely with pro audio gear, most of it likely calls for a +4 dBu line level signal, but some pro audio gear might have a switch that allows you swap inputs between a -10 dBV and +4 dBu mode.The Gain Reduction meter shows how much the audio level is reduced. Use the Gain parameter to increase the audio level after compressing the signal. The Ratio parameter can be used control the change in dynamic range while Attack and Release parameter changes the temporal behavior. Compressor: Reduces the dynamic range of the audio signal by attenuating audio that exceeds a specific threshold.The meter turns red when there is no audio passing, and yellow during the attack, release, and hold times. The LED meter is green when audio passes through the gate. Auto Gate: Removes noise below a certain amplitude threshold.The different parameters under Dynamic Effects are as follows: Importing video and working with video clips.How to match, fade, and mix clip volume with Audition. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |